Nice running, hard-hitting hammer with great control!

Comes with a set of combo dies and the 3"x6" flat dies shown in the pictures. Its powered by a 5HP, 220v, single phase motor.

The hammer was completely overhauled a couple of years ago. It was re-babbitted where needed and all five rubber cushions were replaced with new ones cast from high-strength rubber (Shore A 40 durometer). Everything is tight and works like its supposed to.

I have it set up with the motor and a jack shaft mounted on a wall beam. The next owner will need to modify that for their shop or make a new motor mount.

The hammer doesn't require any special foundation. Its bolted to a bed of 4'x6" timbers, sitting on a 4" concrete garage slab. Has been running like this for over 15 years with no floor cracks or other issues.

Total weight is approx 3500 pounds. Footprint is 32" x 61" and its 6' tall.

Pickup in Middletown, MD.